Posted on Leave a comment

Mill Gemot – take 2,

A 90% successful mill. Both sides lined up perfectly. Will just have to make the tabs a little more sturdy next time and change the angles of the wing tips in the material. The trailing edge of the foil is obviously too thin as can be seen in the video, but that was more because of the initial 3D model I made. I’ll probably stick a 2mm thick square trailing edge on it so that it’s a clean cut.

We’ll laminate this one and give it a test fly anyway. Hopefully I can edit the 3D and make the next one in the next few days.


Leave a Reply